Gamber-Johnson Surface Base Spezifikationen PDF herunterladen

INSTALLATION INSTRUCTIONS

Product Revision Form #

Horizontal Surface Base B INST-14

DS-56

1. First mount the head or rack on the base, following the instructions furnished

with the head or rack.

2. With the head or rack in the center of tilt range, locate the assembly on the

mounting surface in the desired position. Mark the locations of the four mounting

holes.

3. Drill a 13/32” hole at each mounting hole location, using care not to damage

any equipment below the mounting surface. Use machine bolts and nuts of the

largest size that will fit the holes in the base. Most bases have hoes for 3/8” bolts,

but holes for 1/2” bolts are furnished in the taller bases.

4. Place bolts, washers and nuts in all holes and tighten. We strongly recommend

fender washers if the mounting surface is less than 1/8” thick. Do not use lag

screws or sheet metal screws as these can pull out of the floor.

Product Mounting Disclaimer

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

If you need assistance or have question, call Gamber-Johnson at 1-800-456-6868.

INSTALLATION INSTRUCTIONS 1

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS Product Revision Form # Horizontal Surface Base B INST-14 DS-56 1. First mount the head or rack on the bas

Kommentare zu diesen Handbüchern

Keine Kommentare

Gamber-Johnson Surface Base Spezifikationen

Stöbern Sie online oder laden Sie Spezifikationen nach Montagesätze Gamber-Johnson Surface Base herunter. Gamber-Johnson Surface Base Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Montagesätze Gamber-Johnson Surface Base